Description

International Goldspar Satin

International Goldspar Satin is a one-component interior satin varnish that is quick drying which helps to reduce dust pick up. This traditional varnish provides a hard smooth satin finish which is resistant to mild acids & alkalis.

Product features and benefits

• A satin finish polyurethane varnish, designed primarily for interior use
• Resistant to mild acids and alkalis
• Quick dry formula that reduces dust pickup

Product Data

APPLICATION AND USE

Preparation

PREVIOUSLY VARNISHED WOOD

In Good Condition

Clean with thinners. Sand smooth with 280320 grade paper. Remove sanding dust with thinners.

In Poor Condition

Remove all previous coatings.

BARE WOOD

Ensure that the surface is thoroughly degreased. Sand smooth with 80180 grade paper and then 280 grade paper. Remove sanding dust by brushing, dusting and wiping. If wiping with solvent then allow to dry completely before applying the first coat.

Priming bare wood: Thin the first coat by 1015% with Thinner No.1.

Method

Apply a minimum of 3 unthinned coats, more if using a roller. Avoid using direct from the can. Pour the amount you expect to use in a separate container.

Hints

Mixing Stir well before use.

Thinner

Thinner No.1, Thinner No.3

Cleaner

Thinner No.1

Airless Spray(Professional spray application only)

Pressure: 176210 bar. Tip Size: 13651580.

Conventional Spray(Professional spray application only)

Pressure: 23 bar. Tip Size: 1.11.4 mm. Thin 2530% with Thinners No.3  Roller If applying by roller, lay off with a brush or pad otherwise air bubbles may become trapped in the film.

Other

For Airmix spray application

Pressure: 2 bar. Tip Size: 06113. For best results sand lightly between coats with 320400 grade paper. Avoid using direct from the can. Pour the amount you expect to use in a separate container.

Some Important Points

Only use recommended thinners. Use above the waterline only. Avoid painting in direct sunlight.

Product temperature should be minimum 15°C and maximum 35°C.

Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F.

Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F.

Recommended DFT per coat 40 microns dry by brush

Recommended WFT per coat 87 microns wet by brush