Description

International Danboline

Danboline protects bilges, lockers and bulkheads against moisture penetration, and wear and tear. Danboline will resist oil and fuel spillage and cleans easily.

Product features and benefits

• Hardwearing coating for bilges, lockers and bulkheads
• Chemical resistance to fumes, fuel and oil
• High opacity ensures thorough coverage
• Gloss Finish

Product Data

APPLICATION AND USE Preparation PREVIOUSLY PAINTED SURFACES

In Good Condition

Wash down with Super Cleaner, rinse with fresh water and allow to dry. Abrade with 180280 grade paper.

In Poor Condition

Remove all previous coatings and prime the substrate.

PRIMING

All preparation for bare substrates is covered on the appropriate primer datasheet.

BARE WOOD

Prime with One UP or Interprotect.

STEEL

Prime with One UP or Interprotect.

ALUMINIUM

Prime with One UP or Interprotect.

GRP(GELCOAT)

Wash down with Super Cleaner, rinse with fresh water and allow to dry. Abrade with 180220 grade paper. Particular attention should be given to the reverse side of moulded GRP. No priming necessary. Method Sand the primer using 180280 grade wet or dry paper. Remove dust with a dust wipe. Apply 12 coats.

Hints

Mixing Stir well before use.

Thinner Thinner No.1 (Thinner 910 for spraying)

Cleaner Thinner No.1  and Humidity Control Apply in dry, well-ventilated conditions.  Conventional Spray Pressure: 34 bar. Tip Size: 1.2 mm. Thin approximately 20% with Thinners 910.

SPRAY APPLICATION PROFESSIONAL APPLICATORS ONLY

Other

For added protection against moisture absorption and osmosis in the bilges, use Gelshield products.

Some Important Points

Product temperature should be minimum 15°C and maximum 35°C.  Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F.  Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F.

Compatibility/Substrates Suitable for all substrates specified. Only overcoat with onepack paints.

Number of Coats 12 Coverage (Theoretical) 12.3 m²/L per coat by brush (Practical) 11.0 m²/L per coat Recommended DFT per coat 40 microns dry Recommended WFT per coat 82 microns wet

Application Methods Brush, Conventional Spray, Roller